VLAN Configuration Command Set
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
7-24 Matrix DFE-Platinum and Diamond Series Configuration Guide
7.3.3.10 set vlan constraint
Use this command to apply a constraint to a VLAN.
set vlan constraint vlan-list set-num [shared | independent]
Syntax Description
Command Defaults
If not specified, the VLAN constraint will be set to independent.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to apply a constraint 3 to VLAN 1 using an independent filtering database:
vlan-list Specifies the VLAN(s) for which to apply the constraint.
set-num Specifies a constraint set ID. Valid values are: 1 to 65535.
shared |
independent
(Optional) Sets the constraint type as sharing the same filter
database as other VLANs in this set, or as using an
independent filtering database.
Matrix(rw)->set vlan constraint 1 3 independent
To Next Page
Loading...
