Logging And Network Management Command Set
Configuring RMON
11-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.4.21 set rmon topN status
Use this command to enable an RMON topN entry.
set rmon topN status index enable |
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable RMON TopN entry 1:
index Specifies an index number for this entry. Maximum
number of entries is 10. Maximum value is 65535.
enable Enables this TopN entry.
Matrix(rw)->set rmon topN status 1 enable
To Next Page
Loading...
