Port Configuration Command Set
Enabling / Disabling Jumbo Frame Support
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-49
4.3.5.2 set port jumbo
Use this command to enable or disable jumbo frame support on one or more ports.
set port jumbo {enable | disable} [port-string]
Syntax Description
Command Defaults
If port-string is not specified, jumbo frame support will be enabled or disabled on
all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to enable jumbo frame support for 1-Gigabit Ethernet port 14 in module 3:
This example shows how to enable jumbo frame support for router in slot 2, router instance 1.:
NOTE: By default, jumbo frame support is disabled on all ports and path MTU
discovery is enabled. When jumbo frame support is enabled, path MTU discovery
should not be disabled. For details on setting the path MTU state, refer to
Section 2.2.10.2.
enable | disable Enables or disables jumbo frame support.
port-string (Optional) Specifies the port(s) on which to disable or
enable jumbo frame support. For a detailed description
of possible port-string values, refer to Section 4.1.1.
Matrix(rw)->set port jumbo enable ge.3.14
Matrix(rw)->set port jumbo enable rtr.2.1
To Next Page
Loading...
