Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-87
6.2.1.74 clear spantree default
Use this command to restore default values to a Spanning Tree.
clear spantree default [sid]
Syntax Description
Command Defaults
If sid is not specified, defaults will be restored on Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to restore Spanning Tree defaults on SID 1:
sid (Optional) Restores defaults on a specific Spanning Tree.
Valid values are 0 - 4094. If not specified, SID 0 is
assumed.
Matrix(rw)->clear spantree default 1
To Next Page
Loading...
