Security Configuration Command Set
Configuring Denial of Service (DoS) Prevention
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-183
14.3.14Configuring Denial of Service (DoS) Prevention
Purpose
To configure Denial of Service (DoS) prevention, which will protect the router from attacks and
notify administrators via Syslog.
Commands
The commands used to configure DoS prevention are listed below and described in the associated
section as shown:
• show hostdos (Section 14.3.14.1)
• hostdos (Section 14.3.14.2)
• clear hostdos-counters (Section 14.3.14.3)
ROUTER: These commands can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to Section 2.3.3.
To Next Page
Loading...
