IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-13
10.4.2.6 show igmp config
Use this command to display IGMP configuration information for one or more VLANs.
show igmp config vlan-list
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display IGMP configuration information for VLAN 1:
Table 10-1 shows a detailed explanation of command output. For details on using
the set igmp config command to set these parameters, refer to Section 10.4.2.7.
vlan-list Specifies the VLAN(s) for which to display IGMP
configuration information.
Matrix(rw)->show igmp config 1
IGMP config for vlan 1
VlanQueryInterval - 125
VlanStatus - Active
Vlan IGMP Version - 2
VlanQuerier - 134.141.22.1
VlanQueryMaxResponseTime - 10
VlanRobustness - 2
VlanLastMemberQueryIntvl - 10
VlanQuerierUpTime - 24039
To Next Page
Loading...
