Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
11-112 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.5.11 show mac
Use this command to display the timeout period for aging learned MAC addresses, and to show
MAC addresses in the switch’s filtering database. These are addresses learned on a port through the
switching process or statically entered. To show port MAC addresses programmed into the device
during manufacturing, use the show port mac command as described in Section 11.2.5.10.
show mac [agetime] [address mac-address] [fid fid] [vlan-id vlan-id]
[port-string port-string] [type {other | invalid | learned | self | mgmt}]
[field-decode] [-verbose]
Syntax Description
Command Defaults
If no parameters are specified, all MAC addresses for the device will be displayed.
Command Mode
Read-Only.
agetime (Optional) Display the time in seconds that a learned MAC
address will stay in the filtering database.
address
mac-address
(Optional) Displays a specific MAC address (if it is known
by the device).
fid fid (Optional) Displays MAC addresses for a specific filter
database identifier.
vlan-id vlan-id (Optional) Displays MAC addresses for a specific VLAN
based on the VLAN ID,
for static multicast entries only.
port-string
port-string
(Optional) Displays MAC addresses for a specific port or
range of ports. For a detailed description of possible
port-string values, refer to Section 4.1.1.
type other |
invalid | learned |
self | mgmt
(Optional) Display MAC addresses defined as other,
invalid, learned, self or mgmt (management).
field-decode (Optional) Display the meanings of the fields in the show
mac command.
-verbose (Optional) Displays all MAC address information in detail.
To Next Page
Loading...
Need help?
General