Logging And Network Management Command Set
Configuring RMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-51
11.2.4.2 set rmon stats
Use this command to configure an RMON statistics entry.
set rmon stats index port-string [owner]
Syntax Description
Command Defaults
If owner is not specified, monitor will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to configure RMON statistics entry 2 for fe.1.20:
index Specifies an index for this statistics entry.
port-string Specifies port(s) to which this entry will be assigned. For a
detailed description of possible port-string values, refer to
Section 4.1.1.
owner (Optional) Assigns an owner for this entry.
Matrix(rw)->set rmon stats 2 fe.1.20
To Next Page
Loading...
