Port Configuration Command Set
Enabling / Disabling Jumbo Frame Support
4-48 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.5.1 show port jumbo
Use this command to display the status of jumbo frame support and maximum transmission units
(MTU) on one or more ports.
show port jumbo [port-string]
Syntax Description
Command Defaults
If port-string is not specified, jumbo frame support status for all ports will display.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of jumbo frame support for ge.1.1:
port-string (Optional) Displays the status of jumbo frame support
for specific port(s). For a detailed description of
possible port-string values, refer to Section 4.1.1.
Matrix(rw)->show port jumbo ge.1.1
Port Number Jumbo Oper Status Jumbo Admin Status Jumbo MTU
----------- ----------------- ------------------ ---------
ge.1.1 Disabled Disabled 10239
To Next Page
Loading...
