Logging And Network Management Command Set
Configuring Node Aliases
11-142 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.7.2 show nodealias mac
Use this command to display node alias entries based on MAC address and protocol.
show nodealias mac mac_address [ip | apl | mac | hsrp | dhcps | dhcpc | bootps |
bootpc | ospf | vrrp | ipx | xrip | xsap | ipx20 | rtmp | netBios | nbt | bgp | rip |
igrp | dec | bpdu | udp] [port-string]
Syntax Description
mac_address Specifies a MAC address for which to display node alias
entries. This can be a full or partial address.
ip | apl | mac |
hsrp | dhcps |
dhcpc | bootps |
bootpc | ospf |
vrrp | ipx | xrip |
xsap | ipx20 |
rtmp | netBios |
nbt | bgp | rip |
igrp | dec | bpdu |
udp
(Optional) Displays node alias entries for one of the
following protocols:
• Internet Protocol
• Appletalk
• Media Access Control
• Hot Standby Routing Protocol
• Dynamic Host Control Protocol Server
• Dynamic Host Control Protocol Client
• Boot Protocol Server
• Boot Protocol Client
• Open Shortest Path First
• Virtual Router Redundancy Protocol
• Internet Packet Exchange
• IPX Routing Information Protocol
• IPX Service Access Point
• PX Protocol 20 packet
• Routing Table Maintenance Protocol
• NetBIOS (raw)
• NetBIOS (over TCP/IP)
• Border Gateway Protocol
• Routing Information Protocol
• Interior Gateway Routing Protocol
• Digital Equipment Corporation
• Bridge Protocol Data Unit
• User Datagram Protocol
port-string (Optional) Displays node alias properties for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
To Next Page