Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.65 show spantree backuproot
Use this command to display the state of the Spanning Tree backup root function.
show spantree backuproot [sid]
Syntax Description
Command Defaults
If sid is not specified, status will be shown for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the backup root function on SID 0:
sid (Optional) Displays status for a specific Spanning Tree.
Valid values are 0 - 4094. If not specified, SID 0 is
assumed.
Matrix(rw)->show spantree backuproot
Backup Root is set to disable on sid 0
To Next Page
Loading...
