VLAN Configuration Command Set
Configuring the VLAN Egress List
Matrix DFE-Platinum and Diamond Series Configuration Guide 7-33
7.3.4.3 clear vlan egress
Use this command to remove ports from a VLAN’s egress list.
clear vlan egress vlan-list port-string [forbidden]
Syntax Description
Command Defaults
If forbidden is not specified, tagged and untagged settings will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to remove Fast Ethernet port 14 in module 3 from the egress list of
VLAN 9:
This example shows how to remove all Fast Ethernet ports in module 2 from the egress list of
VLAN 4:
vlan-list Specifies the number of the VLAN from which a port(s)
will be removed from the egress list.
port-string Specifies one or more ports to be removed from the VLAN
egress list of the specified vlan-list. For a detailed
description of possible port-string values, refer to
Section 4.1.1.
forbidden (Optional) Clears the forbidden setting from the specified
port(s) and resets the port(s) as able to egress frames if so
configured by either static or dynamic means.
Matrix(rw)->clear vlan egress 9 fe.3.14
Matrix(rw)->clear vlan egress 4 fe.2.*
To Next Page
Loading...
Need help?
General