Logging And Network Management Command Set
Configuring RMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-65
11.2.4.12 set rmon event properties
Use this command to configure an RMON event entry, or to create a new event entry with an unused
event index number.
set rmon event properties index [description description] [type {none | log | trap
| both}] [community community] [owner owner]
Syntax Description
Command Defaults
• If description is not specified, none will be applied.
• If not specified, type none will be applied.
• If owner is not specified, monitor will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
index Specifies an index number for this entry. Maximum
number of entries is 100. Maximum value is 65535.
description
description
(Optional) Specifies a text string description of this event.
type none | log |
trap | both
(Optional) Specifies the type of RMON event notification
as: none, a log table entry, an SNMP trap, or both a log
entry and a trap message.
community
community
(Optional) Specifies an SNMP community name to use if
the message type is set to trap. For details on setting
SNMP traps and community names, refer to
Section 5.3.6.
owner owner (Optional) Specifies the name of the entity that
configured this entry.
To Next Page
Loading...
Need help?
General