Enterasys Matrix 2G4072-52 - Show Multiauth Idle-Timeout

Security Configuration Command Set
Configuring Multiple Authentication
14-146 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.10.11 show multiauth idle-timeout
Use this command to display the multiple authentication timeout value for an idle session. This will
display the idle-timeout vlaues, in seconds, for the following authentication types: dot1x, pwa, mac,
and cep.
show multiauth idle-timeout
Syntax Description
None
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
None
Example
This example shows how to display timeout values for an idle session, for each of the authentication
types:
Matrix(rw)->show multiauth idle-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 300
pwa 300
mac 300
cep 300