Logging And Network Management Command Set
Configuring RMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-83
11.2.4.25 set rmon matrix status
Use this command to enable an RMON matrix entry.
set rmon matrix status index enable
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable RMON matrix entry 1:
index Specifies an index number for this entry. Maximum
number of entries is 2. Maximum value is 65535.
enable Enables or disables this matrix entry.
Matrix(rw)->set rmon matrix status 1 enable
To Next Page
Loading...
