Enterasys Matrix 2G4072-52 - Clear Inlinepower Powertrap

General Configuration Command Set
Configuring Power over Ethernet (PoE)
2-104 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.5.7 clear inlinepower powertrap
Use this command to reset chassis power trap messaging back to the default state of disabled.
clear inlinepower powertrap
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset chassis power trap messaging to disabled:
Matrix(rw)->clear inlinepower powertrap