IGMP Configuration Command Set
Enabling / Disabling IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-5
10.4.1.2 set igmp enable
Use this command to enable IGMP on one or more VLANs.
set igmp enable vlan-list
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable IGMP on VLAN 104:
vlan-list Specifies the VLAN(s) on which to enable IGMP.
Matrix(rw)->set igmp enable 104
To Next Page
Loading...
