Logging And Network Management Command Set
Configuring SMON
11-38 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.3.1 show smon priority
Use this command to display SMON user priority statistics. SMON generates aggregated statistics
for IEEE 802.1Q VLAN environments.
show smon priority [port-string] [priority priority]
Syntax Description
Command Defaults
• If port-string is not specified, SMON statistics for all ports will be displayed.
• If priority is not specified, statistics for all priority queues will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SMON priority 0 statistics for 1-Gigabit Ethernet port 14 in
module 3
:
port-string (Optional) Displays SMON priority statistics being
collected by specific port(s). For a detailed description of
possible port-string values, refer to Section 4.1.1.
priority priority (Optional) Displays SMON statistics based on encoded user
priority, Valid values are 0 - 7.
Matrix(rw)->show smon priority ge.3.14 0
Show Priority Statistics
------------------------
Interface = ge.3.14
Owner = none
Creation = 0 days 0 hours 6 minutes 39 seconds
Status = enabled
--------------------
Priority 0 Packets Octets
----------
Total 7981308 2332402460
Overflow 0 0
To Next Page
Loading...
Need help?
General