Spanning Tree Configuration Command Set
Configuring Spanning Tree Loop Protect Features
6-136 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.3.15 set spantree lptrapenable
Use this command to enable or disable Loop Protect event notification.
set spantree lptrapenable {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Usage
Loop Protect traps are sent when a Loop Protect event occurs, that is, when a port
goes to listening due to not receiving BPDUs. The trap indicates port, SID and loop
protection status.
Example
This example shows how to enable sending of Loop Protect traps:
enable | disable Enable or disable the sending of Loop Protect traps. Default
is disabled.
Matrix(rw)->set spantree lptrapenable enable
To Next Page
Loading...
