Logging And Network Management Command Set
Configuring System Logging
11-6 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.1.2 show logging server
Use this command to display the Syslog configuration for a particular server.
show logging server [index]
Syntax Description
Command Defaults
If index is not specified, all Syslog server information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Syslog server configuration information. For an explanation of
the command output, refer back to Table 11-1.
index (Optional) Displays Syslog information pertaining to a
specific server table entry. Valid values are 1-8.
Matrix(rw)->show logging server
IP Address Facility Severity Description Port Status
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5) default 514 enabled
2 132.140.90.84 local4 warning(5) default 514 enabled
To Next Page
Loading...
