Enterasys Matrix 2G4072-52 - Clear Spantree Lplock

Spanning Tree Configuration Command Set
Configuring Spanning Tree Loop Protect Features
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-125
6.2.3.5 clear spantree lplock
Use this command to manually unlock a blocked port and optionally, per SID. The default state is
unlocked.
clear spantree lplock port-string [sid sid]
Syntax Description
Command Defaults
If no SID is specified, SID 0 is assumed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to clear Loop Protect lock from ge.1.1:
port-string Specifies port(s) for which to clear the Loop Protect lock.
For a detailed description of possible port-string values,
refer to Section 4.1.1.
sid sid (Optional) Specifies the specific Spanning Tree(s) for
which to clear the Loop Protect lock. Valid values are 0 -
4094. If not specified, SID 0 is assumed.
Matrix(rw)->show spantree lplock port ge.1.1
LoopProtect Lock status for port ge.1.1 , SID 0 is LOCKED.
Matrix(rw)->clear spantree lplock ge.1.1
Matrix(rw)->show spantree lplock port ge.1.1
LoopProtect Lock status for port ge.1.1 , SID 0 is UNLOCKED.