IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12-100 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.8.19 allow accessservers
Use this command to allow specific clients to access the load balancing real servers in a particular
LSNAT server farm without address translation. Specified clients can set up connections directly to
the real servers’ IP addresses, as well as to the virtual server IP address (VIP).
For more information about using this command, see “Configuring Direct Access to Real Servers”
on page 12-71.
allow accessservers client-ip-start client-ip-end
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes non-LSNAT access permission from the
specified clients:
no allow accessservers client-ip-start client-ip-end
Command Type
Router command.
Command Mode
SLB Virtual Server Configuration mode: Matrix>Router1(config-slb-vserver)#
Command Defaults
None.
Example
This example shows how to allow clients at 10.24.16.12 through 10.24.16.42 non-LSNAT access
to the virtual server named “virtual-http”:
client-ip-start Specifies an IP address at the start of the range of clients to
be allowed access.
client-ip-end Specifies an IP address at the end of the range of clients to
be allowed access.
Matrix>Router1(config)#ip slb vserver virtual-http
Matrix>Router1(config-slb-vserver)#allow accessservers 10.24.16.12 10.24.16.42
To Next Page
Loading...
Need help?
General