Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-80 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.67 clear spantree backuproot
Use this command to reset the Spanning Tree backup root function to the default state of disabled.
clear spantree backuproot sid
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the backup root function to disabled on SID 2:
sid Specifies the Spanning Tree on which to reset the backup
root function. Valid values are 0 - 4094.
Matrix(rw)->clear spantree backuproot 2
To Next Page
Loading...
