Enterasys Matrix 2G4072-52 - Clear Lldp

Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-56 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.4.19 clear lldp
Use this command to return LLDP parameters to their default values.
clear lldp {all | tx-interval | hold-multipler | trap-interval | med-fast-repeat}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example returns the transmit interval to the default value of 30 seconds.
all Return all LLDP configuration parameters to their default
values, including port LLDP configuration parameters.
tx-interval Return the number of seconds between transmissions of
LLDP frames.to the default of 30 seconds.
hold-multiplier Return the multiplier to apply to the transmit interval to
determine the time-to-live value to the default value of 4.
trap-interval Return the minimum time between LLSP trap
transmissions to the default value of 5 seconds.
med-fast-repeat Return the number of fast start LLDPDUs to be sent when
an LLDP-MED endpoint device is detected to the default
of 3.
Matrix(rw)->clear lldp tx-interval