Security Configuration Command Set
Configuring TACACS+
14-32 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.4.7 set tacacs session
Use this command to enable or disable TACACS+ session accounting, or to configure TACACS+
session authorization parameters. For simplicity, separate syntax formats are shown for configuring
session accounting and session authorization.
set tacacs session accounting {enable | disable}
set tacacs session authorization {service name | read-only attribute value |
read-write attribute value | super-user attribute value}
Syntax Description
accounting Specifies that TACACS+ session accounting is being
configured.
enable | disable Enables or disables TACACS+ session accounting.
authorization Specifies that TACACS+ session authorization is being
configured.
service name Specifies the name of the service that the TACACS+ client
will request from the TACACS+ server. The name
specified here must match the name of a service configured
on the server.
read-only
attribute value
Specifies that the Matrix read-only access privilege level
should be matched to a privilege level configured on the
TACACS+ server by means of an attribute-value pair
specified by attribute and value.
By default, attribute is “priv-lvl” and value is 0.
read-write
attribute value
Specifies that the Matrix read-write access privilege level
should be matched to a privilege level configured on the
TACACS+ server by means of an attribute-value pair
specified by attribute and value.
By default, attribute is “priv-lvl” and value is 1.
super-user
attribute value
Specifies that the Matrix super-user access privilege level
should be matched to a privilege level configured on the
TACACS+ server by means of an attribute-value pair
specified by attribute and value.
By default, attribute is “priv-lvl” and value is 15.
To Next Page
Loading...
