SNMP Configuration Command Set
Configuring SNMP Users, Groups and Communities
5-22 Matrix DFE-Platinum and Diamond Series Configuration Guide
5.3.2.7 show snmp community
Use this command to display SNMP community names and status. In SNMPv1 and v2, community
names act as passwords to remote management.
show snmp community [name]
Syntax Description
Command Defaults
If name is not specified, information will be displayed for all SNMP communities.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display information about the SNMP “public” community name. For a
description of this output, refer to set snmp community (Section 5.3.2.8):
name (Optional) Displays SNMP information for a specific
community name.
Matrix(rw)->show snmp community public
--- Configured community strings ---
Name = public
Security name = public
Context =
Transport tag =
Storage type = nonVolatile
Status = active
To Next Page
Loading...
Need help?
General