IGMP Configuration Command Set
Configuring IGMP
10-28 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.2.19 show igmp counters
Use this command to display IGMP counter information.
show igmp counters
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the IGMP counters:
Matrix(rw)->show igmp counters
Igmp Counters:
Igmp Group Table is Full : false
Igmp Version 1 Queries transmitted : 0
Igmp Version 2 Queries transmitted : 1016368
Igmp Version 3 Queries transmitted : 0
Igmp Group Specific Queries transmitted : 0
Igmp Queries received : 776482
Igmp Version 1 Joins received : 0
Igmp Version 2 Joins received : 1024
Igmp Version 3 Joins received : 22
Igmp Leave Groups received : 0
Igmp Dropped Frames : 22
To Next Page
Loading...
Need help?
General