Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-33
3.2.4.6 show lldp port local-info
Use this command to display the local system information stored for one or more ports. You can use
this information to detect misconfigurations or incompatibilities between the local port and the
attached endpoint device (remote port).
show lldp port local-info [port-string]
Syntax Description
Command Defaults
If port-string is not specified, local system information will be displayed for all
ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the local system information stored for port fe.4.1. Table 3-4
describes the output fields of this command.
port-string (Optional) Displays local system information for one or a
range of ports.
Matrix(rw)->show lldp port local-info fe.4.1
Local Port : fe.4.1 Local Port Id: fe.4.1
--------------------
Port Desc : ... 100BASE-TX RJ21 Fast Ethernet Frontpanel Port
Mgmt Addr : 10.21.64.100
Chassis ID : 00-E0-63-93-74-A5
Sys Name : LLDP PoE test Chassis
Sys Desc : Enterasys Networks, Inc. Matrix E7 Gold Rev 05.41
Sys Cap Supported/Enabled : bridge,router/bridge
Auto-Neg Supported/Enabled : yes/yes
Auto-Neg Advertised : 10BASE-T, 10BASE-TFD,
100BASE-TX, 100BASE-TXFD,
1000BASE-TFD,
Bpause
To Next Page
Loading...
Need help?
General