EasyManuals Logo

Enterasys Matrix 2G4072-52 User Manual

Enterasys Matrix 2G4072-52
1422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1106 background imageLoading...
Page #1106 background image
Routing Protocol Configuration Command Set
Configuring RIP
13-4 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.2.1 router rip
Use this command to enable or disable RIP configuration mode.
router rip
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command disables RIP:
no router rip
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to enable RIP:
NOTE: You must execute the router rip command to enable the protocol before
completing many RIP-specific configuration tasks. For details on enabling configuration
modes, refer to Table 2-9 in Section 2.3.3.
Matrix>Router1#configure terminal
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys Matrix 2G4072-52 and is the answer not in the manual?

Enterasys Matrix 2G4072-52 Specifications

General IconGeneral
BrandEnterasys
ModelMatrix 2G4072-52
CategorySwitch
LanguageEnglish

Related product manuals