Routing Protocol Configuration Command Set
Configuring RIP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-3
Specify a RIP version. ip rip send version (Section 13.2.2.7)
ip rip receive version (Section 13.2.2.8)
Configure RIP authentication. key chain (Section 13.2.2.9)
key (Section 13.2.2.10)
key-string (Section 13.2.2.11)
accept-lifetime (Section 13.2.2.12)
send-lifetime (Section 13.2.2.13)
ip rip authentication keychain (Section 13.2.2.14)
ip rip authentication mode (Section 13.2.2.15)
Disable automatic route summarization
(necessary for enabling CIDR)
no auto-summary (Section 13.2.2.16)
Disable triggered updates. ip rip disable-triggered-updates (Section 13.2.2.17)
Disable or re-enable split horizon
poison-reverse.
ip split-horizon poison (Section 13.2.2.18)
Control the processing of routing updates. passive-interface (Section 13.2.2.19)
receive interface (Section 13.2.2.20)
distribute-list (Section 13.2.2.21)
Enable redistribution from non-RIP
routes.
redistribute (Section 13.2.2.22)
Table 13-1 RIP Configuration Task List and Commands (Continued)
To do this... Use these commands...
To Next Page
Loading...
