Enterasys Matrix 2G4072-52 - Set System Name

General Configuration Command Set
Setting Basic Device Properties
2-76 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3.26 set system name
Use this command to configure a name for the system.
set system name [string]
Syntax Description
Command Defaults
If string is not specified, the system name will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system name to Information Systems:
string (Optional) Specifies a text string that identifies the system.
NOTE: A name string containing a space in the
text must be enclosed in quotes as shown in the
example below.
Matrix(rw)->set system name “Information Systems”