Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-57
3.2.4.20 clear lldp port status
Use this command to return the port status to the default value of both (both transmitting and
processing received LLDPDUs are enabled).
clear lldp port status port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-write.
Example
This example returns port ge.1.1 to the default state of enabled for both transmitting and processing
received LLDPDUs.
port-string Specifies the port or range of ports to be affected.
Matrix(rw)->clear lldp port status ge.1.1
To Next Page
Loading...
