Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-99
6.2.2.7 set spantree protomigration
Use this command to reset the protocol state migration machine for one or more Spanning Tree
ports. When operating in RSTP mode, this forces a port to transmit MSTP BPDUs.
set spantree protomigration port-string true
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the protocol state migration machine on fe.1.12:
port-string Specifies the port(s) for which protocol migration mode
will be enabled. For a detailed description of possible
port-string values, refer to Section 4.1.1.
true Enables protocol migration mode.
Matrix(rw)->set spantree protomigration fe.1.12 true
To Next Page
Loading...
Need help?
General