General Configuration Command Set
Resetting the Device
2-150 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.12 Resetting the Device
Purpose
To reset one or more device modules, to clear the user-defined switch and router configuration
parameters, or to schedule a system reset in order to load a new boot image.
Commands
The commands used to reset the device and clear the configuration are listed below and described
in the associated sections as shown.
• show reset (Section 2.2.12.1)
• reset (Section 2.2.12.2)
• reset at (Section 2.2.12.3)
• reset in (Section 2.2.12.4)
• clear config (Section 2.2.12.5)
To Next Page
Loading...
