Routing Protocol Configuration Command Set
Configuring OSPF
13-38 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.3.5 ip ospf priority
Use this command to set the OSPF priority value for router interfaces. The priority value is
communicated between routers by means of hello messages and influences the election of a
designated router.
ip ospf priority number
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the value to the default of 1:
no ip ospf priority
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the OSPF priority to 20 for VLAN 1:
number Specifies the router’s OSPF priority in a range from 0 to
255.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf priority 20
To Next Page
Loading...
