Enterasys Matrix 2G4072-52 - Set Tacacs Command

Security Configuration Command Set
Configuring TACACS+
14-36 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.4.10 set tacacs command
Use this command to enable or disable TACACS+ accounting or authorization on a per-command
basis.
set tacacs command {accounting | authorization} {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Usage
In order for per-command accounting or authorization by a TACACS+ server to
take place, the command must be executed within an authorized session.
When per-command accounting is enabled, the TACACS+ server will log
accounting information, such as start and stop times, IP address of the client, and
so forth, for each command executed during the session.
When per-command authorization is enabled, the TACACS+ server will check
whether each command is permitted for that authorized session and return a
success or fail. If the authorization fails, the command is not executed.
Example
This example shows how to enable TACACS+ authorization on a command basis.
accounting |
authorization
Specifies either TACACS+ accounting or authorization to
be enabled or disabled.
enable | disable Enable or disable accounting or authorization on a
per-command basis.
Matrix(rw)->set tacacs command authorization enable