Configuring LACP
Configuring Link Aggregation
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-111
4.5.4.10 set singleportlag
Use this command to enable or disable the formation of single port LAGs. When enabled, this
maintains LAGs when only one port is receiving protocol transmissions from a partner.
set lacp singleportlag {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable single port LAGs:
enable | disable Enables or disables the formation of single port LAGs.
Matrix(rw)->set lacp singleportlag enable
To Next Page
Loading...
Need help?
General