Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
4-74 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.8.4 set linkflap globalstate
Use this command to globally enable or disable the link flap detection function. By default, the
function is disabled globally and on all ports. If disabled globally after per-port settings have been
configured using the commands later in this chapter, per-port settings will be retained.
set linkflap globalstate {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to globally enable the link trap detection function:
disable | enable Globally disables or enables the link flap detection
function.
Matrix(rw)->set linkflap globalstate enable
To Next Page
Loading...
Need help?
General