Enterasys Matrix 2G4072-52 - Set Igmp Protocols

IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-23
10.4.2.14 set igmp protocols
Use this command to changes the IGMP classification of received IP frames
set igmp protocols [classification classification] [protocol-id protocol-id]
[modify]
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to change IGMP routing protocols to a protocol id of 3:
classification
classification
Specifies the classification. Options are:
• 1-multicast data
• 2-routing protocol
• 3-ignore
protocol-id
protocol-id
The protocol ids to change(0-255).
modify Add to existing classifications. If not used, protocols will
be overwritten.
Matrix(rw)->set igmp protocols classification 2 protocol-id 3
modify