General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-57
2.2.3.10 set system utilization threshold
Use this command to set the threshold for sending CPU utilization notification messages. The
value range is [1..1000] and represents the % of system utilization to use as the trap
threshold.
set system utilization threshold threshold
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system utilization threshold to 100%:
threshold Specifies a threshold value (in 1/10 of a percent).Valid
range is 1 - 1000. A value of 0 will disable utilization
notification messages.
Matrix(rw)->set system utilization threshold 1000
To Next Page
Loading...
