Enterasys Matrix 2G4072-52 - Set Spantree Autoedge

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-53
6.2.1.40 set spantree autoedge
Use this command to enable or disable the automatic edge port detection function.
set spantree autoedge {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable automatic edge port detection:
disable | enable Disables or enables automatic edge port detection.
Matrix(rw)->set spantree autoedge disable