Enterasys Matrix 2G4072-52 - Ip Rip Receive Version

Routing Protocol Configuration Command Set
Configuring RIP
13-12 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.2.8 ip rip receive version
Use this command to set the RIP version(s) for update packets accepted on the interface.
ip rip receive version {1 | 2 | 1 2 | none}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command restores the default version of the RIP module
update packets that are accepted on the interface:
no ip rip receive version
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the RIP receive version to 2 for update packets received on VLAN 1:
1 Specifies RIP version 1.
2 Specifies RIP version 2.
1 2 Specifies RIP versions 1 and 2.
none Specifies that no RIP routes will be processed on this
interface.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip rip receive version 2