Port Priority and Rate Limiting Configuration Command Set
Configuring Quality of Service (QoS)
Matrix DFE-Platinum and Diamond Series Configuration Guide 9-11
9.3.3 Configuring Quality of Service (QoS)
Purpose
To configure Layer 2 QoS transmit queues on one or more ports.
Command Descriptions
The commands to configure the Quality of Service are listed below and described in the associated
section.
• show port txq (Section 9.3.3.1)
• set port txq (Section 9.3.3.2)
• clear port txq (Section 9.3.3.3)
To Next Page
Loading...
