IGMP Configuration Command Set
Configuring IGMP
10-8 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.2.1 show igmp query
Use this command to display the IGMP query status of one or more VLANs.
show igmp query vlan-list
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the IGMP query state for VLAN 1:
vlan-list Specifies the VLAN(s) for which to display IGMP query
state.
Matrix(rw)->show igmp query 1
IGMP querying on vlan 1 is Disabled
To Next Page
Loading...
