Enterasys Matrix 2G4072-52 - Set Lacp Outportalgorithm

Configuring LACP
Configuring Link Aggregation
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-125
4.5.4.19 set lacp outportAlgorithm
Use this command to set the algorithm LACP will use for outport determination.
set lacp outportAlgorithm {dip-sip | da-sa | round-robin}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the LACP outport algorithm to DA-SA:
dip-sip Specifies that destination and source IP addresses will
determine the LACP outport.
da-sa Specifies that destination and source MAC addresses will
determine the LACP outport.
round-robin Specifies that the round-robin algorithm will determine
the LACP outport.
Matrix(rw)->set lacp outportalgorithm da-sa