Enterasys Matrix 2G4072-52 - Clear Spantree Txholdcount

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-63
6.2.1.50 clear spantree txholdcount
Use this command to reset the transmit hold count to the default value of 6.
clear spantree txholdcount
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the transmit hold count:
Matrix(rw)->clear spantree txholdcount