Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-24 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.12 set spantree msti
Use this command to create or delete a Multiple Spanning Tree instance.
set spantree msti sid sid {create | delete}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create MST instance 2:
sid sid Sets the Multiple Spanning Tree ID. Valid values are 1 -
4094.
NOTE:
Matrix Series devices will support up to
64 MST instances (with additional 128 MB
memory installed).
create | delete Creates or deletes an MST instance.
Matrix(rw)->set spantree msti sid 2 create
To Next Page
Loading...
