Policy Classification Configuration Command Set
Configuring Policy Profiles
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-9
8.3.1.4 show policy invalid
Displays information about the action the device will apply on an invalid or unknown policy.
show policy invalid {action | count | all}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display invalid policy action and count information:
action | count | all Shows the action the device should take if asked to apply an
invalid or unknown policy, or the number of times the
device has detected an invalid/unknown policy, or both
action and count information.
Matrix(rw)->show policy invalid all
Current action on invalid/unknown profile is: Forward packets
Number of invalid/unknown profiles detected: 4
To Next Page
Loading...
