Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-53
8.3.2.15 show policy autoclear
Use this command to display the status of the policy auto clear function.
show policy autoclear {all | link | interval | profile | ports}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display all auto clear status information. In this case, the auto clear
function has not been configured:
all Displays all auto clear status information.
link Displays rule usage when a link’s operating status of up is
detected.
interval Displays the interval in minutes at which the device will
automatically clear rule usage statistics.
profile Displays profiles for which rule usage has been cleared
when an assigned profile has been activated.
ports Displays port(s) on which rule usage statistics will be
automatically cleared by one of the auto clear actions
(link/interval/profile).
Matrix(rw)->show policy autoclear all
AutoClear interval is 0 minute(s)
AutoClear on link status is DISABLED
AutoClear on profile status is DISABLED
AutoClear port-list: none
To Next Page
Loading...
Need help?
General