Enterasys Matrix 2G4072-52 - Ip Local Pool

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-117
12.2.9.2 ip local pool
Use this command to configure a local address pool to use as a DHCP subnet. This defines the range
of IP addresses to be used by DHCP server and enables IP local pool configuration mode.
ip local pool name subnet mask
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the local address pool:
no ip local pool name subnet mask
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to configure a local address pool called “localpool” on IP subnet
172.20.28.0/24. Mask can also be expressed as 255.255.255.0:
name Specifies a name for the local address pool.
subnet Specifies an IP subnet for the local address pool.
mask Specifies a subnet mask for the local address pool. Valid
entries are: x.x.x.x or /x.
Matrix>Router1(config)#ip local pool 172.20.28.0/24
Matrix>Router1(ip-local-pool)#